[Date Prev][Date Next]
[Chronological]
[Thread]
[Top]
Re: (ITS#9018) dynlist don't close connection
On Thu, May 02, 2019 at 10:40:21AM +0000, i.harbuz@velcom.by wrote:
> Any ldapsearch commands work fine if request doesn't hit into dynlist.
> If request hit in dynlist then it output information and hanged up.
Hello Ihar,
it seems you have configured dynlist as a global overlay. I would note
that not many overlays fully support this type of configuration at the
moment and might not function correctly.
It is possible that dynlist will do just fine for your use case. Make
sure you test with a simpler scenario as well (where databases are not
subordinate and/or without back-meta in the picture) to see if there
might be interaction between them.
Do let us know if you decide to investigate further and find a minimal
use case where things start to break. Also a full test script that sets
up a self-contained environment and reliably triggers the issue would
greatly improve our chances of diagnosing it correctly.
Thanks,
--
OndÅ?ej KuznÃk
Senior Software Engineer
Symas Corporation http://www.symas.com
Packaged, certified, and supported LDAP solutions powered by OpenLDAP